Manuale Officina Honda Nt700v Deauville
Click Here ::: https://urloso.com/2ty1Pw
How to Service Your Honda NT700V Deauville Motorcycle
If you own a Honda NT700V Deauville motorcycle, you may want to perform some basic maintenance tasks to keep it in peak operating condition. This article will guide you through the service procedures for the NT700V Deauville, based on the official service manual[^1^]. You will need some tools, such as a wrench, a screwdriver, a funnel, and a measuring cup. You will also need some fluids, such as engine oil, coolant, and final drive oil. Before you start, make sure you have read the safety precautions and warnings in the manual.
Step 1: Check the Air Cleaner
The air cleaner is located under the seat. To access it, you need to remove the seat by turning the ignition switch to OFF and inserting the key into the helmet holder lock. Pull up the seat release lever and lift off the seat. Then, remove the two bolts that secure the air cleaner cover and lift off the cover. You will see the air cleaner element inside. Check if it is dirty or damaged. If it is, replace it with a new one. To install the new element, align it with the air cleaner housing and press it into place. Then, reinstall the cover and the seat.
Step 2: Check the Engine Oil Level
The engine oil level should be checked before each ride. To do so, park the motorcycle on a level surface and hold it upright. Start the engine and let it idle for a few minutes. Then, stop the engine and wait for 2-3 minutes. Remove the oil filler cap/dipstick from the right side of the engine and wipe it clean with a cloth. Insert it back into the oil filler hole without screwing it in. Pull it out again and check the oil level. It should be between the upper and lower marks on the dipstick. If it is low, add some recommended oil through the oil filler hole until it reaches the upper mark. Do not overfill. Screw in the oil filler cap/dipstick securely.
Step 3: Check the Coolant Level
The coolant level should be checked when the engine is cold. To do so, remove the right side cover by pulling out its tabs from the grommets on the frame. Locate the coolant reservoir behind the side cover. The coolant level should be between the upper and lower marks on the reservoir. If it is low, add some recommended coolant through the filler opening until it reaches the upper mark. Do not overfill. Reinstall the side cover.
Step 4: Check the Final Drive Oil Level
The final drive oil level should be checked every 12 months or 12,000 km (7,500 miles). To do so, place the motorcycle on its center stand on a level surface. Remove the final drive oil filler cap from the rear wheel hub and wipe it clean with a cloth. Check if there is any oil on its lower end. If there is none, add some recommended oil through the filler hole until it starts to drip from
the lower end of
the cap. Do not overfill.
Reinstall
the cap
securely.
Step 5: Check
the Tyre Pressure
and Tread Wear
The tyre pressure
and tread wear
should be checked
before each ride.
To do so,
use a tyre pressure gauge
to measure
the pressure
of both tyres
when they are cold.
The recommended pressure
is 250 kPa (36 psi) for
the front tyre
and 290 kPa (42 psi) for
the rear tyre.
If they are low,
inflate them to
the correct pressure
using an air pump.
Do not overinflate.
Then,
check
the tread wear
of both tyres
by looking at
the wear indicators
on
the tyre surface.
The wear indicators
are small bars of rubber that appear when
the tread depth
reaches 1 mm (0.04 in).
If any of them are visible,
replace
the tyre with a new one of
the same size and type.
Conclusion
These are some of
the basic service procedures for
the 061ffe29dd